Categories
Your Cart

Rebar Tying Tool

Rebar Tying Tool
Rebar Tying Tool
Rebar Tying Tool
Rebar Tying Tool
Rebar Tying Tool
Rebar Tying Tool
Rebar Tying Tool
Rebar Tying Tool
Rebar Tying Tool
€50 per day +VAT
€150 per week +VAT

The Makita 18v rebar tying tool is fitted with a brushless motor for maximum run times and enables the fast and efficient application of rebar tie wire, reducing the need for GC07 Hot-work permits and reliance on manual labour.

It delivers double loop ties at the press of a button and is ideal for time-consuming construction tasks like laying concrete foundations over a wide area.

It can be used one-handed in either single or continuous mode, leaving the other hand free to adjust the position of the rebar.

The tool is suitable for use with D10, D13 and D16 rebar in varying combinations of 2, 3 and 4 pieces

In continuous mode the operator can make multiple ties simply by pushing the contact arm against the workpieces while holding the trigger down.

According to the condition of the tying material, the tying strength can be adjusted in six stages.

Using a 5Ah 18v battery, up to 120 ties of 0.8mm diameter annealed wire can be accomplished.

Specifications
Voltage18v
Maximum Output340w
Tie Wire0.8mm
Applicable RebarsD10 x D10 - (D13 x2) x (D13 x2)
Approximate ties per reel120 with 5 amp battery
Vibration no load2.5 m/sec²
Vibration K factor1.5 m/sec²
Noise sound pressure:78 dB(A)
Noise K factor3 dB(A)
Weight2.6kg
This site uses cookies. By continuing to browse the site, you are agreeing to our use of cookies.